HP 3000 Manuals

(Subsystem 98)(Continued) [ MPE/iX Error Messages Manual Volume II ] MPE/iX 5.5 Documentation


MPE/iX Error Messages Manual Volume II

(Subsystem 98)(Continued) 

------------------------------------------------------------

2030         MESSAGE    INIT_SSM_DEVICE - An error occurred replaying
                      log.

-------------------------------------------------------------

2031         MESSAGE    CHANGE_SSM_DEVICE_LIMITS - An error was received
                      from POST.

-------------------------------------------------------------

2032         MESSAGE    GET_FREE_SPACE_HISTOGRAM - An error was received
                      from PREFETCH.

-------------------------------------------------------------

2033         MESSAGE    REMAP_SSM_MAP - An error occurred in creating the
                      objects for the new SSM MAP.

-------------------------------------------------------------

2034         MESSAGE    REMAP_SSM_MAP - An error occurred when updating
                      the disk volume label with the sector offset of the
                      new SSM MAP.

-------------------------------------------------------------

2035         MESSAGE    UPDATE_SEC_STORAGE_MAP - One of the page counters
                      went negative after the secondary storage map was
                      updated.  This is currently a bug catcher, but may
                      become permanent.

-------------------------------------------------------------

2036         MESSAGE    VALIDATE_SEC_STORAGE - This is a bad LDEV
                      parameter.

-------------------------------------------------------------

2037         MESSAGE    VALIDATE_SEC_STORAGE - This is a bad DISC_ADDRESS
                      parameter.

-------------------------------------------------------------

2038         MESSAGE    VALIDATE_SEC_STORAGE - The parameter number of
                      bytes is less than zero.

-------------------------------------------------------------

2039         MESSAGE    VALIDATE_SEC_STORAGE - The ending page to be
                      validated exceeded the last page of the device.

-------------------------------------------------------------

2040         MESSAGE    VALIDATE_SEC_STORAGE - The number of byte MOD
                      PAGE_SIZE is not zero.

-------------------------------------------------------------

2041         MESSAGE    VALIDATE_SEC_STORAGE - The page being validated
                      was not a permanent page.

-------------------------------------------------------------

2042         MESSAGE    VALIDATE_SEC_STORAGE - A trap occurred during
                      VALIDATE_SEC_STORAGE.

-------------------------------------------------------------

2043         MESSAGE    SSM_REPLAY_LOG - A trap occurred while XM was
                      recovering the SSM MAP.

-------------------------------------------------------------

2044         MESSAGE    DISMOUNT_SSM_DEVICE - A trap occurred during
                      DISMOUNT_SSM_DEVICE.

-------------------------------------------------------------

2045         MESSAGE    SSM_VERIFY_MAPS_FOR_MOUNTED_SYS_VOLS page counts
                      in map header does not match the bit map count.

-------------------------------------------------------------

2046         MESSAGE    SSM_SA_VERIFY_ENTIRE_MAP - An error was received
                      from PREFETCH in SSM_SA_VERIFY_ENTRE_MAP.

-------------------------------------------------------------

2047         MESSAGE    SSM_SA_INIT_SSM_GLOBAL_AREA - CB_INIT failed.

-------------------------------------------------------------

2048         MESSAGE    SSM_SA_INIT_SSM_GLOBAL_AREA - CREATE_OBJECT
                      failed.

-------------------------------------------------------------

2049         MESSAGE    SSM_SA_UPDATE_SEC_STORAGE_MAP - VERIFY_MAP
                      failed.

-------------------------------------------------------------

2050         MESSAGE    UPDATE_SEC_STORAGE_MAP - One of the page counters
                      went negative before the SECONDARY STORAGE MAP was
                      updated.  This is currently a bug catcher, but may
                      become permanent.

-------------------------------------------------------------

2051         MESSAGE    UPDATE_SEC_STORAGE_MAP - UPDATE_SEC_STORAGE_MAP
                      failed.

-------------------------------------------------------------

2100         MESSAGE    A general system abort occurred for XM (used only
                      until new aborts are added to DSYSFAIL).

-------------------------------------------------------------

2101         MESSAGE    The procedure XM_RECOVERY detected an unknown
                      record type in an XM log.

-------------------------------------------------------------

2102         MESSAGE    The procedure XM_RECOVERY received bad status
                      from SM_OPEN_FD.

-------------------------------------------------------------

2103         MESSAGE    The procedure XM_RECOVERY received bad status
                      from SM_OPEN_OBJECT.

-------------------------------------------------------------

2104         MESSAGE    The procedure XM_CLOSE_RESIDUAL received bad
                      status from SM_CLOSE.

-------------------------------------------------------------

2105         MESSAGE    The procedure XM_CLOSE_RESIDUAL received bad
                      status from POST.

-------------------------------------------------------------

2106         MESSAGE    The procedure XM_RECOVERY detected key is not in
                      the HASH TABLE.

-------------------------------------------------------------

2107         MESSAGE    The procedure XM_RECOVERY_POST_AND_CLOSE received
                      bad status from SM_CLOSE.

-------------------------------------------------------------

2108         MESSAGE    The procedure XM_RECOVERY_POST_AND_CLOSE received
                      bad status from POST.

-------------------------------------------------------------

2109         MESSAGE    The procedure XM_RECOVERY_SETUP detected a
                      failure in CREATE_OBJECT.

-------------------------------------------------------------

2110         MESSAGE    The procedure XM_RECOVERY_SETUP detected a
                      failure in LM_GET_MAGIC_UFID.

-------------------------------------------------------------

2111         MESSAGE    The procedure XM_RECOVERY_SETUP detected a
                      failure in SM_OPEN_FD.

-------------------------------------------------------------

2112         MESSAGE    The procedure XM_RECOVERY_SETUP detected a
                      failure in SM_OPEN_OBJECT.

-------------------------------------------------------------

2113         MESSAGE    The procedure XM_RECOVERY_SETUP detected a bad
                      pointer for the SSM free space map.

-------------------------------------------------------------

2114         MESSAGE    The procedure XM_RECOVERY_SETUP detected a bad
                      pointer for a label table.

-------------------------------------------------------------

2115         MESSAGE    The procedure XM_DB_PROC detected a bad convert
                      in the DST.

-------------------------------------------------------------

2116         MESSAGE    The procedure XM_CLOSELOGFILES received bad
                      status.

-------------------------------------------------------------

2117         MESSAGE    The procedure XM_RECOVERY received bad status
                      from XM_MAP_IN_LT_EXT.

-------------------------------------------------------------

2118         MESSAGE    The procedure XM_MAN_IN_LT_EXT received a bad
                      status from VSM.

-------------------------------------------------------------

2119         MESSAGE    The procedure XM_RECOVERY hit a bugcatcher.

-------------------------------------------------------------

2120         MESSAGE    The procedure XM_ADDACTXID detected an overflow
                      in the number of pool entries.

-------------------------------------------------------------

2121         MESSAGE    The procedure XM_ADDGUFD detected too many GUFD
                      entries.

-------------------------------------------------------------

2122         MESSAGE    The procedure XM_GETBIT_N_LABELUFID received bad
                      FILE ID.

-------------------------------------------------------------

2123         MESSAGE    The procedure XM_PINGOINAWAY received bad status
                      from XM_FINDTRANSROW.

-------------------------------------------------------------

2124         MESSAGE    The procedure XM_GETPOINTER received bad status
                      from STMGT.

-------------------------------------------------------------

2125         MESSAGE    The procedure XM_DEFERDETACH received bad status
                      from XM_GETXID.

-------------------------------------------------------------

2126         MESSAGE    The procedure XM_DEFERDETACH release of file from
                      log was unsuccessful.

-------------------------------------------------------------

2127         MESSAGE    The procedure XM_ABORTUSERXA received bad status
                      from XMABORTTRAN.

-------------------------------------------------------------

2128         MESSAGE    The procedure XM_ABORTUSERXA received bad status
                      from FINDPINROW.

-------------------------------------------------------------

2129         MESSAGE    The procedure XM_DELETEOBJID detected an invalid
                      record type.

-------------------------------------------------------------

2130         MESSAGE    The procedure XM_ALLOCATEBLOCK detected no more
                      disk space.

-------------------------------------------------------------

2131         MESSAGE    The procedure XM_RELEASEPOINTER received bad
                      status from SM_CLOSE.

-------------------------------------------------------------

2132         MESSAGE    The procedure XM_CLOSE detected an unrecognized
                      option; bad input parameter.

-------------------------------------------------------------

2133         MESSAGE    The procedure XM_ALLOCATERECORD detected no more
                      room to allocate records.

-------------------------------------------------------------

2134         MESSAGE    The procedure XM_ALLOCATERECORD detected an
                      unassigned or invalid parameter.

-------------------------------------------------------------

2135         MESSAGE    The procedure XM_DEALLOCATERECORD detected the
                      entry was already released.

-------------------------------------------------------------

2136         MESSAGE    The procedure XM_DEALLOCATERECORD detected an
                      unrecognizable or invalid parameter.

-------------------------------------------------------------

2137         MESSAGE    The procedure XM_DELETETRANSROW detected an
                      invalid input parameter.

-------------------------------------------------------------

2138         MESSAGE    The procedure XM_DELETETRANSROW detected an
                      invalid input parameter.

-------------------------------------------------------------

2139         MESSAGE    The procedure XM_ADDLSROW received bad status
                      from CB_INIT.

-------------------------------------------------------------



MPE/iX 5.5 Documentation