HP 3000 Manuals HP 3000 Manuals
ARITRAP
NM and CM callable (differences noted below).
Collectively enables all arithmetic traps (except the IEEE inexact result
trap) or disables all arithmetic traps.
Syntax
_____________________________________
| |
| I*V |
| ARITRAP(trapstate); |
_____________________________________
Parameters
trapstate (NM)32-bit signed integer by value (required)
(CM)16-bit signed integer by value (required)
(NM) Enables/disables arithmetic traps:
Value Meaning
0 Disable all arithmetic traps
1 Enable all arithmetic traps (except the IEEE inexact
result trap)
(CM) Enables/disables CM arithmetic traps.
Operation Notes
There is a difference between arming and enabling traps. Enabling a trap
means that the occurrence of a trap condition is not ignored. Arming a
trap is required so that, on a trap condition, a user-written routine is
invoked and can take appropriate recovery actions. The following list
summarizes what can happen when an arithmetic trap condition occurs:
* If a trap is both enabled and armed, the user-written trap handler
is invoked.
* If a trap is enabled but not armed, one of two situations apply:
* If a Pascal/XL TRY statement was executed, pass control to
the RECOVER block by doing an ESCAPE.
* If a Pascal/XL TRY statement was not executed, an error
message is output and the process aborts.
* If a trap is disabled, even though it is armed, the trap is
ignored, and execution of the process continues without any
interruption.
NOTE By default, all traps (except the IEEE inexact result trap) are
enabled and the system trap handler is armed.
(NM) The possible interrupts listed below are collectively called the
arithmetic traps:
* 3000 mode double-precision divide by zero
* 3000 mode double-precision overflow
* 3000 mode double-precision underflow
* 3000 mode floating-point divide by zero
* 3000 mode floating-point overflow
* 3000 mode floating-point underflow
* 3000 mode packed decimal error
* Decimal divide by zero
* Decimal overflow
* IEEE floating-point divide by zero
* IEEE floating-point underflow
* IEEE floating-point overflow
* IEEE floating-point, invalid operation
* Integer divide by zero
* Integer overflow
* Invalid ASCII digit
* Invalid decimal digit
* Paragraph stack overflow
* Range errors
* Result of software-detected pointer arithmetic misaligned or error
in conversion from long pointer to short pointer
* Software-detected NIL pointer reference
* Unimplemented condition traps
NOTE The IEEE inexact result trap is not enabled by ARITRAP.
(CM) The possible interrupts listed below are collectively called the
arithmetic traps:
* 3000 mode double-precision divide by zero
* 3000 mode double-precision overflow
* 3000 mode double-precision underflow
* 3000 mode floating-point divide by zero
* 3000 mode floating-point overflow
* 3000 mode floating-point underflow
* Decimal divide by zero
* Decimal overflow
* Integer divide by zero
* Integer overflow
* Invalid ASCII digit
* Invalid decimal digit
* Invalid decimal operand length
* Invalid source word count
Condition Codes
CCE (2) Request granted. All arithmetic traps were
originally disabled.
CCG (0) Request granted. At least one arithmetic trap was
originally enabled.
CCL (1) Not returned.
Related Information
Intrinsics XARITRAP
Commands None
Manuals Trap Handling Programmer's Guide (32650-90026)