HP 3000 Manuals

System Startup, Configuration, and Shutdown Reference Manual

Configuring the Console 

Some of the terminal configuration parameters are important for proper AP
operation.  Both terminals connected to ports T0 (system console) and T1
(remote support modem port) should be configured with the following
parameter settings:

From the DATACOMM CONFIGURATION menu:

     Parity/DataBits  None/8
     Chk Parity  NO
     EnqAck  YES
     CS(CB)Xmit  NO
     RecvPace  Xon/Xoff
     XmitPace  NONE

From the TERMINAL CONFIGURATION menu:

     LocalEcho  OFF
     SPOW(B)  NO
     Line/Page(D)  LINE  (**necessary during control mode**)
     ReturnDef  Return 

Parameters not mentioned can be set to any value and do not affect AP
operation.


NOTE  The AP is designed to operate with the HP 700/92 terminal.  There
      have been no deliberate steps taken to preclude operation with
      other terminals (for example, the AP does not check the terminal
      identification and refuse to operate with anything else), but no
      other terminals have been tested for proper operation.  Use other
      terminals at your own risk.

MPE/iX 5.0 Documentation