HP 3000 Manuals HP 3000 Manuals
DUMP Sequence Refer to Chapter 3 for information on the steps involved in the DUMP process. The following represents a DUMP sequence for Series 950 through Series 955 systems received at the console. DUMP sequences for other installations may vary.
CAUTION Do not use the RS command from the console or push the reset button on the front panel to reset the system for a dump. Hard resetting the system initiates a processor self-test that invalidates dump data.
CM> TC Processor Dependent Code (PDC) revision 3.2 Console path = 2/4.1.0.0.0.0.0 Primary boot path = 2/4.0.0.0.0.0.0 Alternate boot path = 6/4.3.0.0.0.0.0 32 MB of memory configured and tested. Soft Booted- -memory state is valid Autoboot from primary path enabled. To override, press any key within 10 seconds. ** A key is pressed ** Boot from primary boot path (Y or N)?> Y Interact with IPL (Y or N)?> Y Booting. Console IO Dependent Code (IODC) revision 4 Boot IO Dependent Code (IODC) revision 4 Booted. MMSAVE Version 2.2 DUMPAREA found, save main memory to disc ISL loaded ISL Revision A.00.28 July 15, 1993 ISL> DUMP MPE/XL launch facility MPE/XL Dump Version A.00.00 - initialization A full dump, including secondary storage, was requested. Enter user identification string for this dump (80 chars or less): TEST DUMP 6/9/88 Initialize_genesis - Version : <<870204.1552>> WED, JUN 8, 1988, 2:30:04 PM (y/n)? [TMUX_DAM] 15 7 12 14 Initialize memory manager completed. MPE/XL Dump Facility Version A.00.00 Determine pre-compression size of secondary storage for ldev1 52 Megabytes of transient objects will be dumped for this device Determine pre-compression size of secondary storage for ldev2 6 Megabytes of transient objects will be dumped for this device Tape compression enabled. density set at 6250 BPI on tape drive tape is ready Begin dump of Processor Internal Memory. Processor Internal Memory dump complete. Begin dump of main memory. 32 Megabytes of main memory will be dumped ................ Dump of memory save area complete. ................ Main memory dump complete. Begin dump of secondary storage for ldev1 52 Megabytes of transient objects will be dumped for this device .................................................... Secondary storage dump for ldev1 complete. Begin dump of secondary storage for ldev2 7 Megabytes of transient objects will be dumped for this device .... Secondary storage dump for ldev2 complete. Dump completed - autoboot in progress. Processor Dependent Code (PDC) revision 2.8 Console path = 2/4.1.0.0.0.0.0 Primary boot path = 2/4.0.0.0.0.0.0 Alternate boot path = 6/4.3.0.0.0.0.0 32 MB of memory configured and tested. Soft Booted- -memory state is valid Autoboot from primary path enabled. To override, press any key within 10 seconds. 10 seconds expired- -proceeding with autoboot Console IO Dependent Code (IODC) revision 3 Boot IO Dependent Code (IODC) revision 3 Booted. MMSAVE Version 9.90 DUMPAREA protected, proceeding to ISL without memsave ISL loaded ISL Revision 2738 September, 1987 Cannot find an auto-execute file. AUTOBOOT ABORTED. ISL>