HP 3000 Manuals HP 3000 Manuals
Connecting the Remote Support Modem to a Session Port
This command is valid from the remote support modem port only.
Entering SE causes the remote support modem port to connect through to a
session port. If DTR is on, the remote support port's modem remains
connected. The remote support modem is able to initiate a session using
a normal connection protocol, as if a new modem connection had just been
established. To reenter control mode, the remote support port modem must
drop the connection and redial.
Using this command and the port operation, a user at the Response Center
is able to use control, console, and session mode without any
intervention by the local operator. (The operator must enable remote
capability of the system.)
The following message is generated if the local console operator tries to
execute the SE command:
Command may not be executed by local user. (APERR 15)