HP 3000 Manuals HP 3000 Manuals
MOUNT
The MOUNT command mounts a disk volume making it accessible to DISCUTIL.
If an LDEV represents a disk and the device is responding, DISCUTIL
attempts to mount the volume. Once a new volume has been mounted, it is
available to DISCUTIL. Only volumes that have been initialized as a
volume MASTER or MEMBER can be mounted.
Task
Mounts a volume.
Capability
No special capability required.
Syntax
MOUNT [LDEV=] ldev
Parameter
ldev A number from 1 to 100 specifying the logical
device number of the volume to be mounted.
Required.
Example
This example shows how to make a volume accessible to DISCUTIL.
1. Use the DSTAT command to determine the state of the volume.
2. Use the MOUNT command to mount the volume.
________________________________________________________
| |
| |
| discutil>DSTAT |
| |
| |
| LDEV-TYPE STATUS VOLUME (VOLUME SET - GEN) |
| --------- ------ -------------------------- |
| 11-079350 MEMBER BVOL1 (BSET-0) |
| 12-079350 MEMBER BVOL2 (BSET-0) |
| |
| discutil> MOUNT 13 |
| |
| *Note: VOLUME MOUNTED ON LDEV 13 |
| |
| discutil>DSTAT |
| |
| |
| LDEV-TYPE STATUS VOLUME (VOLUME SET - GEN) |
| --------- ------ -------------------------- |
| 11-079350 MEMBER BVOL1 (BSET-0) |
| 12-079350 MEMBER BVOL2 (BSET-0) |
| 13-079350 MEMBER BVOL3 (BSET-0) |
| |
| |
________________________________________________________