HP 3000 Manuals

Switch Programming User's Guide

SWAT Requirements 

The Switch Assist Tool is designed to run on MPE XL-based systems.  SWAT
has certain hardware and software requirements.

Hardware Requirements 

SWAT requires the minimum system configuration listed below for operation
on MPE XL-based systems:
 *  1 900 Series System Processing Unit
 *  1 System disc
 *  1 System printer
 *  1 System tape drive
 *  1 Block mode terminal (as supported by VPLUS/XL)

Software Requirements 

In addition to the SWAT program file (SWAT.PUB.SYS), the tool requires
the following additional system software:

 *  VPLUS/XL fast form file SWATFORM (part of the tool)

 *  VPLUS/XL subsystem

 *  Pascal run-time library

 *  Message catalog file SWATCAT

 *  NLS message catalog subsystem


NOTE  All of the above are part of the Fundamental Operating Software
      (FOS).


To compile the source code generated by SWAT, you must have the HP
Pascal/XL compiler.

MPE/iX 5.0 Documentation