HP 3000 Manuals HP 3000 Manuals
C[ONTINUE]
Continues/resumes execution of user program.
Syntax
C[ONTINUE]
C[ONTINUE] [IGNORE]
C[ONTINUE] [NOIGNORE]
The program executes until a breakpoint is encountered or the program
completes.
Used to exit Debug when it was entered via the DEBUG command at the CI.
Parameters
[NO]IGNORE This parameter is meaningful only in two states. The
first is when Debug has stopped due to one of the MPE XL
traps defined in the TRAP command (XLIB, XCODE, XARI,
XSYS). The default value is NOIGNORE. If you wish to
have the trap ignored (pretend it never happened), you
must use the IGNORE option.
The second state is when the debugger has stopped due to
a SETDUMP command. That is, the process is about to be
killed by the trap handler and Debug has been called.
If one just continues from this state, the process is
terminated. If the IGNORE option is specified, the
process is relaunched as if the error did not occur. It
is up to the user to update registers and the process
stack as appropriate to enable the process to continue
correctly.
Examples
%cmdebug > c
Limitations, Restrictions
The CONTINUE command cannot be used from within macro bodies that are
invoked as a function.
This command resumes execution of your program or the CI if you entered
the debugger with a DEBUG command. If you wish to abort your program or
session, use the ABORT command.
CAUTION The output format of all System Debug commands is subject to
change without notice. Programs that are developed to
postprocess System Debug output should not depend on the exact
format (spacing, alignment, number of lines, uppercase or
lowercase, or spelling) of any System Debug command output.