HP 3000 Manuals

System Debug Reference Manual

CM 

Enters compatibility mode (cmdat/cmdebug).  See the NM command.

Syntax 

      CM

The command switches from NM (nmdat/nmdebug) to CM (cmdat/cmdebug).  If
the windows are on, the screen is cleared and the set of windows enabled
for cmdebug is redrawn.  The command also sets several environment
variables.  The variables affected and their new values are shown below:

     ENV  MODE     "CM"
     ENV  INBASE   CM_INBASE
     ENV  OUTBASE  CM_OUTBASE

Parameters 

none

Examples 

     $nmdebug > cm 
     %cmdebug >

Switch from nmdebug to cmdebug.

Limitations, Restrictions 

none


CAUTION  The output format of all System Debug commands is subject to
         change without notice.  Programs that are developed to
         postprocess System Debug output should not depend on the exact
         format (spacing, alignment, number of lines, uppercase or
         lowercase, or spelling) of any System Debug command output.

MPE/iX 5.0 Documentation