HP 3000 Manuals HP 3000 Manuals
NM Breakpoints in Translated Code The following discussion assumes that the current Debug mode is NM (prompt is: $nmdebug > ). NM breakpoints can be set at every instruction within translated code even if the instruction is not at a node point. This allows careful inspection of the actual sections of NM translated code.
NOTE Portions of the CM state may be undefined or incorrect when a NM breakpoint is encountered between node points.
For example, the following commands set two breakpoints. The first is at a node point, and the second is not at a node point: $nmdebug > B $1c.34d4 $nmdebug > B $1c.34ec Translated Object Code NM Instructions Sid.Off +-------------+ 1c.34b0 N | PROC+%0 | 1c.34b4 | | 1c.34b8 | | 1c.34bc | | 1c.34c0 N | PROC+%2 | 1c.34c4 | | 1c.34c8 | | 1c.34cc | | 1c.34d0 | | 1c.34d4 [1] N | PROC+%6 | 1c.34d8 | | 1c.34dc | | 1c.34e0 | | 1c.34e4 N | PROC+%13 | 1c.34e8 | | 1c.34ec [2] | | 1c.34f0 | | +-------------+ The single step command (S) can be used to step through individual NM Instructions within translated code.