HP 3000 Manuals HP 3000 Manuals
wH
Window home. Returns a window to its original location.
Syntax
RH CM registers window
GRH NM general registers window
SRH NM special registers window
PH Program window, current mode
CMPH CM program window
NMPH NM program window
QH CM frame window - Q relative
SH CM stack window - S relative
GH Group window
UH [win_number] User window
VH [virtaddr] [win_number] Virtual window
ZH [realaddr] Real memory window
LH [ldev.off] LDEV window
TXH [win_number] Text window
This command returns the specified window to its original (home)
location. (This is the location specified when the window was created.)
This command is useful when a window has been scrolled (F,B) or jumped
(J) away from its home location. The virtual (V), real (Z), and LDEV (L)
windows may have their home location respecified with this command by
supplying a new home location.
Parameters
win_number The window number for a specific user window (U), text
window (TX), or virtual window (V). If win_number is
omitted, then the current window is used. The current
user window is marked by an asterisk, and the current
virtual and text windows are marked in inverse video.
virtaddr If this parameter is provided, the home address for the
virtual window (V) is set to the indicated address.
Virtaddr can be a short pointer, a long pointer, or a
full logical code pointer.
realaddr If this parameter is provided, the home address for the
real window (Z) is set to the indicated real address.
ldev.off The disk LDEV and byte offset to which the home address
is set.
Examples
%cmdebug > PH
Home the program window.
$nmdebug > VH PSP-40 4
Change the home address for virtual window 4 to be the value of PSP-40.
Jump the window to the new home address.
%cmdebug > UH 3
Home user window 3.
Limitations, Restrictions
none