HP 3000 Manuals HP 3000 Manuals
Program Windows for Object Code Translation
A CM code segment (XLSEG11) has been translated by the Object Code
Translator (OCT). The CM program window (top) is aimed at the original CM
object code. The NM program window (middle) is aimed at the
corresponding section of translated code. Fields within the windows that
are unique to translated code are described below. Refer to appendix C
for a discussion of CM object code translation, node points, and
breakpoints in translated CM code.
_________________________________________________________________________________________
| |
| |
| cmP % SYS 22.5206 (T) XLSEG11 CST 23 Level 0 |
| 005206:N @[1] ?FOPEN 170404 .. LRA P-4 |
| 005207: FOPEN+%5 030400 1. SCAL O |
| 005210:N [2] FOPEN+%6 000600 .. ZERO, NOP |
| 005211: [3] FOPEN+%7 051451 S) STOR Q+%51 |
| 005212:N FOPEN+%10 140060 .0 BR P+%60 |
| 005213: FOPEN+%11 140003 .. BR P+3 |
| 005214:N [1] ?FSOPEN 170412 .. LRA P-%12 |
| nmP$ TRANS 24.6b7bb8 (translated CM Seg SYS %22 XLSEG11) Level 0,0 |
| 006b7bb8:N @[1] ?FOPEN 340c1504 LDO 2690(0),12 |
| 006b7bbc: 34191510 LDO 2696(0),25 |
| 006b7bc0: 0c991264 STHS,MA 25,2(0,4) |
| 006b7bc4: d19adff0 EXTRS,>= 12,31,16,26 |
| 006b7bc8: e680e792 BLE,N 968(7,20) |
| 006b7bcc: e566204e BLE,N 53284(4,11) |
| 006b7bd0:N [2] FOPEN+%6 0800024c OR 0,0,12 |
| 006b7bd4:N 646c00a4 STH 12,82(0,3) |
| 006b7bd8:N FOPEN+%10 e8000232 B,N $006b7cf8 |
| Commands |
| %31 (%44) cmdebug > |
| |
_________________________________________________________________________________________
window banner line
* (T) - The CM segment is currently running in translated mode.
* TRANS 24.6b7bb8 - The NM program window is aimed at translated code.
The original CM segment is identified as SYS %22 XLSEG11.
window body line(s)
* Node points are denoted by N.
* breakpoints - Breakpoints are displayed between the offset and the
procedure name. Refer to the conventions pages for a description of
all possible breakpoint notations.
@[1] global breakpoint, index number 1
[2] process local breakpoint, index number 2
* procedurename+offset - The NM program window shows where each node
point is in the original CM object code. The "?" indicates an entry
point for CM procedure names. Refer to chapter 2, section "Procedure
Name Symbols" for details on the conventions used for procedure
names.