HP 3000 Manuals HP 3000 Manuals
x4confcat
Concatenate and display the X.400 configuration files.
Syntax
________________________________________________________________________
|x4confcat |
________________________________________________________________________
Description
x4confcat concatenates then displays the .conf files as well as the
.conf.new files in the /usr/lib/x400 directory if they are different from
the corresponding .conf files.
NOTE The X.400 configuration information for X.400 is in the .conf files
in the directory /usr/lib/x400. The X.400 components use the
configuration information in these files.
When you press the Perform Task key in a configuration screen,
changes made to the X.400 configuration are written to temporary
files, .conf.new files. Any changes you make in x4admin are made
to these .conf.new files, not to the .conf files.
When you enable the configuration in x4admin, the .conf.new files
are copied to the .conf files, and the .conf.new files are deleted.
If you exit x4admin without enabling the configuration, you are
asked to save or delete the .conf.new files. If you save the
files, the next time you run x4admin and enter the Configure X.400
Menu, you are warned that the configuration information used is the
information in the .conf.new files, not the .conf files being used
by the X.400 components.
The output may be displayed on your screen or redirected to a file. For
example,
x4confcat > filename
redirects the output to the specified file name.