HP 3000 Manuals

Using the Node Management Services (NMS) Utilities

ADDLDEV 

Adds LDEVs to a DTC card.

Syntax 

              {dtcname}
     ADDLDEV  {dtc-nodename} [filename]
              {station-address}

Parameters 

dtcname             The NMMGR nametag for the DTC being accessed.  The
                    nametag is the last name in the pathname of the DTC.
                    For example, the dtcname is DTC01 in the pathname
                    DTS.DTC.SELECT.DTC01.  The dtcname in a one to eight
                    character alphanumeric string.

dtc-nodename        The nodename of the DTC that has been configured at
                    the DTC nametag path.  The name must conform to the
                    NODENAME.ORGANIZATION.DOMAIN format.  The name is a
                    five to fifty character alphanumeric string.

station-address     The hexadecimal station of the DTC being accessed.

filename            A text file that contains the LDEVs to be added or
                    purged.  The file name's format is:

                    filename[.groupname[.accountname]]

                    A file lockword may not be specified.  The contents
                    of the file must be formatted as described below.

Description 

This command adds LDEVs to the cards in the DTC's configuration.  The
first DTC found that matches the selection criteria will be operated on.
For example, this could occur if more than one DTC is configured with the
same station-address.

LDEVs for one of more cards can be entered on each invocation of this
command.  If the filename is not specified you will be prompted with the
ADDLDEV>>prompt.  The format for each entry depends on the card type.
The formats for these card types are as follows:

   *   For direct connect or modem cards:

       LDEV[,] cardno[,] portno[,] profilename[,]

   *   For X.25 PAD cards:

       LDEV[,] cardno[,] profilename[,] device-name[,] x25address[,]
       [CUG] [;]

All text following the number sign "#" will be interpreted as a comment.

For X.25 cards the LDEV will be added to the first available line on the
first available page of LDEVs shown on the PAD screen mode.

See also LISTLDEV and PURGELDEV.

Example 

NMMGR> ADDLDEV dtc01.ind.hp

Enter LDEVs;

For M or D type cards:  ldev#, card#, port#, profile#; For x type cards:
ldev#, card#, profile, device, address [, CUG];

     ADDLDEV> 100, 1, 1, tr10d96;                     #jack's terminal
     ADDLDEV> 101, 1, 2, tr10d96;                     #jill's terminal
     ADDLDEV> 102, 1, 3, tr10d96;                     #building 43U,R6
     ADDLDEV> 201, 2, tr10d96, pad1, 123456789012301  #building 41U,A7
     NMMGR>

MPE/iX 5.0 Documentation