HP 3000 Manuals HP 3000 Manuals
DT[C]
Lists each DTC assigned to the system and displays the number that
TermDSM has assigned to each DTC.
Security level: 2.
Syntax
________________________________________________________________________
| |
| |
|DT[C] |
________________________________________________________________________
Description
When this command is entered, information similar to the following is
displayed on the terminal:
Your system has these Distributed Terminal Controllers:
DTC Network
Number Address Name
1 08000900180A BIOLAB
2 080009000808 MARKETING
3 080009001234 TIMESHAREROOM
Use this number as the "DTC number" in TermDSM commands.
The DTC Node Name that was associated with each DTC at configuration time
is displayed along with the IEEE 802.3 station address of each DTC. The
number in the first column is assigned by TermDSM and these numbers must
be used in other TermDSM commands to reference particular DTCs.
After the above display is printed, the major prompt will be printed and
you may enter another TermDSM command.
If, during a TermDSM command, you make an error in specifying a DTC
number, the above display is automatically printed to the terminal for
your convenience.
NOTE The listing of DTCs with an IEEE 802.3 station address and name is
not a guarantee that each DTC exists, is installed, is powered on,
or is otherwise functional. This information is obtained from the
NMCONFIG.PUB.SYS file and is therefore only a reflection of what
has been configured (correctly or otherwise).