HP 3000 Manuals HP 3000 Manuals
Testing the DTC If the DTC is suspected as the cause, TermDSM can be used to determine the hardware or software component involved. It also provides DTC dump and reset functions.
CAUTION TermDSM functions described in this section cause all sessions on the DTC to abort. Data for each session can be lost. Verify that users are logged off before attempting these tests.
Security level 1 (SM or DI capability) is required for the following functions. For details on using TermDSM, refer to chapters 3, "Introduction to TermDSM" and chapter 4, "TermDSM Commands." The DUMP DTC command writes data to a disc file from the software managers serving all the ports on the DTC. The dump file can be read by an HP support representative for detailed diagnosis of software faults. After the dump, the DTC selftest is run automatically. The DTC selftest exercises the following: the DTC processor card; the serial interface cards; and the connector cards. The selftest runs for about 2 minutes. After the selftest, the DTC is downloaded and reset automatically. If you are running TermDSM at the console, messages will be displayed informing you of the download. The selftest isolates faults within Field Replaceable Units (FRU) in the DTC. The faults are indicated by TermDSM messages and by error codes shown on the DTC's LED display. For information on servicing FRUs and reading DTC error codes, refer to the: DTC Installation and Service Manual