Informational Messages [ HP COBOL II/XL Reference Manual ] MPE/iX 5.0 Documentation
HP COBOL II/XL Reference Manual
Informational Messages
---------------------------------------------------------------------------------------
980 ERROR ATTEMPTING TO RECOVER FROM SYNTAX ERROR.
MESSAGE
CAUSE The indicated item is where the compiler is attempting to recover
from the previous syntax error. The items between the two messages
were ignored by the compiler.
---------------------------------------------------------------------------------------
981 ERROR DEBUGGING SECTION ! IGNORED, NO DEBUGGING MODE CLAUSE.
MESSAGE
CAUSE The indicated Debugging Section is ignored because the WITH
DEBUGGING MODE clause was not specified in the SOURCE-COMPUTER
paragraph.
---------------------------------------------------------------------------------------
982 ERROR UNPREDICTABLE OPTIMIZATION RESULTS IF ERRORS OCCUR.
MESSAGE
CAUSE
---------------------------------------------------------------------------------------
992 ERROR COMPILER ERROR: ERROR MESSAGE #! OVERFLOWS BUFFER.
MESSAGE
CAUSE [REV BEG]Only first ~500 bytes are printed.[REV END]
---------------------------------------------------------------------------------------
993 ERROR FAILURE IN INTERNAL CALL TO INTRINSIC GENMESSAGE.
MESSAGE
CAUSE See directions on line .3 of the file COBCAT.PUB.SYS.
---------------------------------------------------------------------------------------
994 ERROR TOO MANY ERRORS FOR ERROR FILE. SOME ERRORS MAY NOT BE LISTED.
MESSAGE
CAUSE
---------------------------------------------------------------------------------------
997 ERROR MISSING ERROR MESSAGE #!.
MESSAGE
CAUSE Check compiler and COBCAT (this file) for proper versions.
---------------------------------------------------------------------------------------
998 ERROR TOO MANY ERRORS.
MESSAGE
CAUSE [REV BEG]The number of errors has exceeded 100 or value in
$ERRORS=.[REV END]
---------------------------------------------------------------------------------------
999 ERROR UNABLE TO CONTINUE. COMPILATION TERMINATED.
MESSAGE
CAUSE
---------------------------------------------------------------------------------------
MPE/iX 5.0 Documentation