HP 3000 Manuals

Introduction to MPE XL for MPE V System Administrators

Storing and Restoring Spoolfiles 

You may use the STORE and RESTORE commands to store spoolfiles to tape
and to restore them to your system.  It is recommended that you use these
commands to move spoolfiles from one system to another so long as both 
systems have the Native Mode Spooler.  For information on transferring
spoolfiles to or from an unlike environment refer to the SPFXFER utility
described later in this chapter.

Storing All Output Spoolfiles 

To store all output spoolfiles to tape, enter: 

     FILE T;DEV=TAPE 
     STORE @.OUT.HPSPOOL;*T;SHOW 

The ;SHOW parameter produces a listing of files stored.  You may enter
;SHOW=OFFLINE for an offline listing. 

Restoring All Output Spoolfiles 

To restore all output spoolfiles to your system, enter: 

     FILE T;DEV=TAPE 
     RESTORE @.OUT.HPSPOOL;*T;SHOW 


NOTE  Input spoolfiles are private and private spoolfiles may not be
      stored.  However, because input spoolfiles are generally used and
      managed by the system there is seldom any reason to store them to
      tape or move them to another system.

[REV END]

[REV
BEG]

MPE/iX 5.0 Documentation