HP 3000 Manuals HP 3000 Manuals
Example Start Procedure
This example illustrates one of several possible Series 930 boot
sequences. It shows the system booted from the Access Port with the
autoboot flag enabled. The same type of sequence executed on the Series
950 differs only in the format of the boot path names.
To initiate the boot sequence, enter CTRLB to place the System Console in
Control Mode. This displays the Control Mode prompt (CM>).
:CTRLB
CM>RS
___________________________________________________________________________
| |
| Execution of this command irrecoverably halts all system |
| processing and I/O activity and restarts the computer system. |
| |
| Type Y to confirm your intention to restart the system (Y/N): Y|
| SPU hardware was successfully reset. |
| |
| Processor Dependent Code (PDC) revision 3 |
| |
| Console path = 8.1.0.0.0.0.0 |
| Primary boot path = 8.0.0.0.0.0.0 |
| Alternate boot path = 16.3.0.0.0.0.0 |
| |
| Autoboot from primary boot path enabled. |
| To override, press any key within 10 seconds. |
| |
| 10 seconds expired. |
| |
| Booting. |
| |
| Console IO Dependent Code (IODC) revision 2 |
| Boot IO Dependent Code (IODC) revision 2 |
| |
| Booted. |
| MMSAVE Version n.nn |
| DUMPAREA found, save main memory to disk |
| ISL loaded |
| |
| ISL Revision nnnn October, 1987 |
| |
| ISL booting START AUTO |
| . |
| . |
___________________________________________________________________________
Example 2-1. Example Start Procedure