HP 3000 Manuals HP 3000 Manuals
Programmatic Control Messages
These informational messages may be displayed by RJE when programmatic
control is being used. For more information about these messages, refer
to the RJE User/Programmer Manual.
---------------------------------------------------------------------------------------
MESSAGE *** SAVED RJOUT IS NEXT ***
(The saved RJOUT command is shown here.)
CAUSE This message is issued when RJE/XL is operating in repeat mode
each time the repeating RJOUT subsystem command is executed.
The saved RJOUT command follows the informational message.
ACTION No action required.
---------------------------------------------------------------------------------------
MESSAGE ** RJOUT INTERRUPTED: MSG. FILE
CAUSE This message is issued when RJE/XL is operating in interrupt
mode each time the subsystem reads a command file name from the
message file.
ACTION No action required.
---------------------------------------------------------------------------------------
MESSAGE ** NEW COMMAND FILE: command file name
CAUSE This message is issued when RJE/XL is operating in interrupt
mode each time the subsystem begins processing commands from a
new command file.
ACTION No action required.
---------------------------------------------------------------------------------------
MESSAGE *COMMAND FILE END OF FILE*
CAUSE This message is issued when RJE/XL is operating in interrupt
mode each time the subsystem finishes processing the last
subsystem command of a command file.
ACTION No action required.
---------------------------------------------------------------------------------------