HP 3000 Manuals

Using SNA IMF Pass Thru

UDCs for Entering Printer Commands 

You can create UDCs for entering the printer commands described in the
last section.  The steps to creating a UDC are as follows: 

   1.  Issue the MPE  SETCATALOG command at the MPE colon prompt. 

            :SETCATALOG

   2.  Use the MPE editor to add the UDC to your UDC file.  Add a row of
       asterisks (*) to separate UDCs in the same file. 

   3.  Issue the MPE  SETCATALOG command to reset your UDC file.

            :SETCATALOG  udcfile 

       See "Creating and Using UDCs," in chapter 3, for step-by-step
       instructions for creating or modifying a UDC file.

MPE/iX 5.0 Documentation