HP 3000 Manuals

HP SNA Products Remote System Configuration Guide

Appendix D  IMS Example 

This appendix contains a sample IMS configuration 
for the HP SNA products described in chapter 4.

To ensure that the host configuration is compatible with HP's SNA
products, there are values that HP requires you set for some parameters.
These values are in bold in this appendix.

If a parameter is in bold but the value for it is not, you must include
the parameter, but you do not have to set it to the value shown.  For
example, OUTBUF= 1536, means you must include the OUTBUF parameter, but
you do not have to set it to 1536.

Required parameters must be coded as specified.  Variable parameters must
be set within the constraints defined by HP and the host.


CAUTION  HP requires that the host be configured as defined in chapter 4
         of this manual.  Any HP time spent solving problems related to
         incorrect configuration of the host is billable to the customer
         on a time and materials basis.  The configuration listings must
         be available to your HP representative in case your installation
         requires servicing.


The following is an example of a definition for an LU.T1, LU.T2, and
LU.T3 for HP's SNA products.

             TYPE UNITTYPE=SLUTYPE2 
     T002    TERMINAL NAME=LUHP002,
     &
                   MODEL=2, 
     &
                   FEAT=(PFK,NOCD), 
     &
                   OUTBUF=1536
              TYPE UNITTYPE=SLUTYPE1 
     P003     TERMINAL NAME=LUHP003,
                   MODEL=2, 
     &
                   MSGDEL=NOTERM, 
     &
                   OUTBUF=1536
     &

MPE/iX 5.0 Documentation