HP 3000 Manuals HP 3000 Manuals
NRJE Manager Commands
Most subsystem commands are available only to NRJE managers (users with
NM capability). Users without NM capability can have access to the
console commands, provided that one or more of the commands have been
"allowed" in the NRJE configuration file. (This is described later in
this chapter.) Table 6-2 summarizes NRJE manager commands.
Table 6-2. NRJE Manager Commands
------------------------------------------------------------------------------------------
| |
| Command Function |
| |
| CONSOLE Obtains access to the host remote console of a workstation. |
| |
| HALT Stops active LU-LU sessions immediately. |
| |
| PURGE Purges entries in the NRJE Joblog. |
| |
| This command does not apply if you are connected to a |
| VSE/POWER host system. |
| |
| RDRDOWN Disables the reader of an NRJE workstation. |
| |
| RDRFENCE Updates the outfence value of the NRJE workstation reader. |
| |
| RDRUP Enables the reader of an NRJE workstation. |
| |
| RELEASE Relinquishes access to the host remote console of a |
| workstation. |
| |
| RELOAD Causes NRJE to reload the Formid Lookup Table. |
| |
| STARTWS Starts a workstation or individual LUs, and optionally |
| starts intrinsic and/or LU tracing. |
| |
| STATUS Displays the current status of LU sessions. |
| |
| STOPWS Stops active LU-LU sessions in an orderly manner. |
| |
| TRACEOFF Turns off intrinsic and/or LU tracing for a workstation. |
| |
| TRACEON Turns on intrinsic and/or LU tracing for a workstation. |
| |
| VERIFY Verifies the entries in the Formid Lookup Table. |
| |
| WELCOME Updates the NRJE subsystem welcome message. |
| |
| []... A host job entry system console command preceded by the host |
| command prefix character configured for the workstation. |
| |
------------------------------------------------------------------------------------------