HP 3000 Manuals HP 3000 Manuals
LAN Error Messages (contd)
39 MESSAGE Bad rendezvous info length.
CAUSE A bad length of rendezvous info was specified in
the rendezvous request.
ACTION Write down the error information displayed on
the console submit an SR and call your
Hewlett-Packard support contact.
--------------------------------------------------------------------------
40 MESSAGE The Middle Plane is in wrong state.
CAUSE The Middle Plane state machine table is
corrupted.
ACTION Write down the error information displayed on
the console submit an SR, take a dump and call
your Hewlett-Packard support contact.
--------------------------------------------------------------------------
41 MESSAGE Missing inbound pool in the rendezvous request
message.
CAUSE The rendezvous request message does not specify
inbound buffer pool.
ACTION Write down the error information displayed on
the console submit an SR, and call your
Hewlett-Packard support contact.
--------------------------------------------------------------------------
42 MESSAGE Missing rendezvous info in the rendezvous
request message.
CAUSE The rendezvous request message does not have a
pointer to the rendezvous information buffer.
ACTION Write down the error information displayed on
the console submit an SR and call your
Hewlett-Packard support contact.
--------------------------------------------------------------------------
48 MESSAGE Unsupported module type in IODC.
CAUSE The problem is caused by bad NIO LAN hardware,
the wrong path number, or the wrong type of
card.
ACTION Try these actions in this order:
1. Verify that the configured physical path
is correct by using NMMGR.
2. Verify that the card is a NIO LAN/console
card.
3. If you have tried both of the actions
above and are still experiencing
difficulties, your Hewlett-Packard
representative must run diagnostics on
the LAN/console card.
--------------------------------------------------------------------------
49 MESSAGE Unsupported software model in IODC.
CAUSE The problem is caused by bad NIO LAN hardware,
the wrong path number, or the wrong type of
card.
ACTION Try these actions in this order:
1. Verify that the configured physical path
is correct by using NMMGR.
2. Verify that the card is a NIO/LAN console
card.
3. If you have tried both of the actions
above and are still experiencing
difficulties, your Hewlett-Packard
representative must run diagnostics on
the LAN/console card.
--------------------------------------------------------------------------
50 MESSAGE The NIO LAN/console card did not return to a
ready state after a reset was issued.
CAUSE The problem is caused by bad NIO LAN/console
hardware.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
52 MESSAGE The NIO LAN/console card register test failed
during LAN/console card initialization.
CAUSE The problem is caused by bad NIO LAN/console
hardware.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
53 MESSAGE Unable to obtain IODC information from
IO_GET_MODULE_REC during initialization.
CAUSE Unknown. Need more information.
ACTION Write down the error information displayed on
the console, submit an SR, and call your
Hewlett-Packard support contact.
--------------------------------------------------------------------------
55 MESSAGE An unknown interrupt type was received from
IO_Services.
CAUSE Unknown. Need more information.
ACTION Write down the error information displayed on
the console, submit an SR, and call your
Hewlett-Packard support contact.
--------------------------------------------------------------------------
57 MESSAGE The NIO LAN/console card detects that bind
request for a given 802.2 SAP or 802.2 SAP +
XSAP or ETHERNET Type is already bound.
CAUSE The problem is caused by a link driver internal
problem.
ACTION Write down the error information displayed on
the console, submit an SR, and call your
Hewlett-Packard support contact.
CAUSE The problem is caused by a bad NIO LAN/console
backplane.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
58 MESSAGE The NIO LAN/console card detects illegal bind
request.
CAUSE The problem is caused by a link driver internal
problem.
ACTION Write down the error information displayed on
the console, submit an SR, and call your
Hewlett-Packard support contact.
CAUSE The problem is caused by a bad NIO LAN/console
backplane.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
59 MESSAGE The NIO LAN/console card detects a bad length of
the configuration data buffer.
CAUSE The problem is caused by data corruption in the
configuration quad.
ACTION Write down the error information displayed on
the console, submit an SR, take a dump and call
your Hewlett-Packard support contact.
CAUSE The problem is caused by a bad NIO LAN/console
backplane.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
60 MESSAGE The NIO LAN/console card detects bad multicast
address in the configuration data.
CAUSE A bad multicast address was entered into the
Multicast Address Table.
ACTION Write down the error information displayed on
the console, submit an SR, and call your
Hewlett-Packard support contact.
CAUSE The problem is caused by a bad NIO LAN/console
backplane.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
61 MESSAGE The NIO LAN/console card detects a bind request
to illegal register.
CAUSE The problem is caused by a link driver internal
error.
ACTION Write down the error information displayed on
the console, submit an SR, and call your
Hewlett-Packard support contact.
CAUSE The problem is caused by a bad NIO LAN/console
backplane.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
62 MESSAGE The NIO LAN/console card detects a bad Station
Address in CONFIG_SA.
CAUSE The problem is caused by configuring the wrong
Station Address in NMMGR.
ACTION Use NMMGR to verify that the configured Station
Address is correct.
CAUSE The problem is caused by a bad NIO LAN/console
backplane.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
63 MESSAGE The NIO LAN/console card detects a bind request
to already bound register.
CAUSE The problem is caused by a link driver internal
error.
ACTION Write down the error information displayed on
the console, submit an SR, and call your
Hewlett-Packard support contact.
CAUSE The problem is caused by a bad NIO LAN/console
backplane.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
64 MESSAGE The NIO LAN/console card detects an unbind
request to an unbound register.
CAUSE The problem is caused by a link driver internal
error.
ACTION Write down the error information displayed on
the console, submit an SR, and call your
Hewlett-Packard support contact.
CAUSE The problem is caused by a bad NIO LAN/console
backplane.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
65 MESSAGE The NIO LAN/console card detects too many
multicast addresses in the configuration buffer.
CAUSE The problem is caused by a link driver internal
error.
ACTION Write down the error information displayed on
the console, submit an SR, and call your
Hewlett-Packard support contact.
CAUSE The problem is caused by a bad NIO LAN/console
backplane.
ACTION Your Hewlett-Packard representative must run
diagnostics on the LAN/console card.
--------------------------------------------------------------------------
66 MESSAGE The NIO LAN/console card reports that expected
CCMD_IN or CCMD_OUT was not found.
CAUSE Unknown. Need more information.
ACTION Write down the error information displayed on
the console and call your Hewlett-Packard
support contact.
--------------------------------------------------------------------------
67 MESSAGE The NIO LAN/console card reports that CCMD_OUT
was sent to an inbound only register set.
CAUSE Unknown. Need more information.
ACTION Write down the error information displayed on
the console and call your Hewlett-Packard
support contact.
--------------------------------------------------------------------------