HP 3000 Manuals HP 3000 Manuals
Establishing PU-SSCP Sessions on the HP 3000
For each node you configure on the HP 3000, a corresponding T2.0 or T2.1
node should be in the remote system configuration. Figure 4-1 shows how
a session is established between the SSCPon the remote system and the PU
on the HP 3000 node (either a T2.0 node or a T2.1 node). The remote
system sends out a poll on the data link, in the form of a Set Normal
Response Mode (SNRM), and continues to poll the link until it receives a
positive response from the HP 3000. The HP 3000 node is activated with
the SNACONTROL STARTcommand (see chapter 6 of this manual). The SSCP
then sends an ACTivate PU (ACTPU)request to the HP 3000 PU. SNA
Transport, as the PU services manager, sends a positive response back to
the SSCP. The PU-SSCP session is now established.
IBM Remote System HP 3000 (T2.0/T2.1 Node)
Link started up from remote system
SSCP polls for null XID
null XID poll
- - - - - ->
If HP 3000 is a T2.0
node,
it sends an XID0
If HP 3000 is a T2.1
node,
XID0 or XID3 it sends an XID3
<- - - - - -
SSCP begins polling link
until positive response
received from HP PU
(SNRM)
- - - - - ->
Link started up on HP 3000
with SNACONTROL START
(SNRM)
- - - - - ->
Link driver on PSI sends
unnumbered
(UA) acknowledgement to SRNM
<- - - - - -
SSCP initiates PU-SSCP
session ACTPU
- - - - - ->
SNA Transport issues positive
(+ response) response to SSCP
<- - - - - -
(PU-SSCP session established)
Figure 4-1. PU-SSCP Session Establishment